dissenting.
There was evidence to require the submission of the issues of fact in the case to a jury.
A former trial of the case resulted in a verdict for the plaintiff, and a judgment refusing to set aside the same was reversed by this court. 95 Ga. 734. The amendment just referred to was made at the last trial; and upon the introduction of the evidence for the plaintiff a nonsuit was granted, to which ruling she excepted. The evidence shows the following: Eslinger was killed about 7 o’clock at night in June, 1892. ITis cheek was crushed in. He was found lying with his cheek next to the rail, and his feet were lying north somewhat diagonally along the track, or across the track. No part of the machinery of the oar was resting on his body. His face was lying close enough to the rail for the flange of the wheel to have miade the wound on Ms face. The track between the rails •where bis body was lying was a smooth place floored in with plank. Witness Torrence testified that, to tbe best of his recollection, all of the body was resting on the plank. Some of the planks are longer than others. The body was lying on the planks between the rails. Torrence would •guess that six or eight or ten inches of Eslinger’s legs were extending over tbe ends of the planks; thinks there was about four or five feet of the plank extending under the stationary car before it was moved; did not measure. After the cars were hit they moved four and a half or five feet, and when they stopped they were right ‘about the end of the planks. Torrence thinks the oar was right about even with the end of the planks, or may be a few inches north of them. The planks are about 'two inches thick. Interrogatories of Torrence were taken about two or three months after the ■accident; his mind was 'then mudh fresher about the accident than it is now. He then swore, that the stationary ear which Eslinger went in to couple was standing about two and a half or three feet over the floor, that is, the end of the floor extended under the car about two and a half or three feet; and that the other stationary car was not over any of the floor at all. In 'answer to the question, whether that testimony is the truth, he says that the end of the boxcar next to the engine was not over the floor. Q. “The one north of the plank?” A. “They was when they bit.” The stationary car that Eslinger went in to couple was standing two and a half or three feet over the plank. The first person to get to him after he was killed was Say. "When Torrence saw him the distance of his head from the end of the floor was about three feet; Ms head was south and bis feet were north. Tbe cars moved about four or five feet after they came together; in going this distance they would have to- pass over the end of the plank floor. Torrence was about a car-length and a half from Eslinger when he went in to couple the cars, which were from 30 to 34 feet in length. The first thing that attracted the atterntion of Torrence was the lamp falling ont that hit the ground, and the next thing was Eslinger halloing, “Oh, Lordy.” Just as the cars came together 'the lamp fell out; he halloed pretty close after. Torrence cannot give any idea as to how many seconds after the cars came together before Eslinger halloed; does not know how long it was between the time the lamp fell out and the time he halloed; swore in the interrogatories that “time elapsing being about four or five seconds when he Was billed from the time he went between the cars”; never timed it, and did not know for certain whether there were four or five seconds. The cars were moving hack very slowly to the stationary oar, and he went in to make the coupling, and just as the oars came together his lamp fell out and he halloed, and Torrence gave the engineer a distress or immediate stop signal, and he stopped. Torrence ran by the engine and told the engineer that Eslinger was killed, and ran around the engine and told tiróse in the office and came right hack. Erom the time he went between the cars to the time he was killed was very short. What Torrence said in his interrogatories must have been as nearly right as he could have gotten it. If he went in about two or three feet from the end of the plank, he went on a perfectly 'smooth and level place. Torrence does not know what was there to make him fall. If the stationary car was up over the end of the planks, and he had to step off the planks, it would he some rougher than on the planks. They are about two inches thick. The lamp falling ont and the halloing were not exactly at the same time; the latter was “right on top” of the former. The cars were barely moving at the time of the coupling. Torrence examined the machinery of the cars after the accident two or three hours; the brake-beam was in good order; he saw nothing wrong about it; it was about eight inches from the floor. The plank was bevelled off close to the rail, leaving a space for the wheels to run in, which space was too wide to catch a foot. The place is now just as it was at the time of the accident. There was a rod that projected from the center of the brake-beam and right under the draw-head, that could not have caught Eslinger unless he had got right between the draw-heads, which would have been a dangerous position if the cars came together. ITe could not have been caught by the bolt in the center of the brake-beam if he was in a standing position between the cars; he would have 'had to be in a reclining position, leaning pretty far back, for the bolt to have caught him. To have made the coupling properly, he would not have had to be closer than 18 or 20 inches of the rod or bolt in the brake-beam. In going in to make the coupling, ■the coupler f ollows 'the moving car after the cars hit. There is no 'absolute necessity to go between the rails to make the coupling; he can stand on'the outside and enter the link and pin, and that is all to be done. The oar was moving very slowly; it stopped within four or five feet after the coupling was made. It was made successfully. Torrence does not know whether it was made before the lamp fell out or not; the lamp fell out about the time the car was hit; guesses Eslinger made the coupling before he halloed; he made it about the time he halloed. The place for the flange of the wheels to run in the floor was wider than was necessary. Torrence put his foot down in that place four or five different times. There was nothing where Eslinger went in to make the coupling to cause him to fall; it is a smooth, safe place. He had been 'coupling cars over this place two months, at different times, along that track and over that place; this was one of the most used tracks in the yard. Torrence has never known an accident to occur at that place before or since this one. The condition of the place has remained unchanged. Eslinger’s work was done at night. There was nothing to prevent the superintendent and yardmaster from seeing the place. From the testimony of Addington, it appears that he was about 100 yards away at the time of the-homicide, and went immediately to the place. He with several others looked at the brake-beam of the car under which Eslinger was killed. The beam was hanging very low, witness thinks not over four inches from the plank. He turned a •tap on bolt that holds the brake-beam; had no trouble to move the bolt; if it had been tightened up, he could not ■have moved it, and it would have raised the brake-beam two inches higher. The usual and ordinary height of a brake-beam is eight inches. Witness had never seen one that low before. It would pitch a man forward if he was in there and his fo'ot caught on the planks. In stepping partly on the plank and partly off them, the low brake-beam would catch a person on the leg. Witness has been caught that way. He assisted in taking Eslinger from under the car; his head looked as if the flange of a wheel had run over it; did not notice any bruises on any other part of his person; his vest was pulled up over his head; did not notice where the brake-beam or any part of it caught his clothing; there was no blood on, the ground and rail where he was lying. The brake-beam was four inches from the rail and four from the ground, which would make it eight inches from the ground, hut for the plank Which were up within an inch or a half-inch from level with the top of the rail. These are estimates: witness did not measure. The plank were two or three inches thick; the step-off from their ends would not exceed three inches. Witness does not know that for the brake-beam to strike Eslinger he must have been leaning toward it and not in a standing attitude. The hrake-beam is under the body of the car and under the bumper. It is about three feet from the brake-beam to where the link is, when you go to make coupling. Eor a man to put a link in a bumper, he would be three feet from the hrake-beam, but his feet would not he that far. He could get Ms foot caught by walking along when the oars come together; he has got to keep them out of the way of the brake-beam, or it will catch him every time. If he keeps his foot up level with his body, then tbe brake-beam will not catcb bim. Q. “Only way for tbe brake-beam to catcb bim is for bis foot to get back under tbe bumper?” A. “Unless it would be in a case of this kind.” John Byrd as an expert testified, among other things,. that it is from four to six or eight inches from the bottom of the brake-beam to the ground. He thinks a brake-beam four inches high would be more likely to catch a brakeonan than one eight inches high; four inches is not enough space in there to let his foot out in case it should get hung, while one eight inches high has enough room to get his foot out and get out of the way, if one with beam four inches high would bang him and drag him under the oar; that has been 'his experience. H a coupler went in to couple a car standing stationary, with the planks extending two or three feet under the end of it, and the place is smooth, witness does not know what would cause him to fall. The engineer of the train which did the killing testified: I do not think it was over a minute after the accident before I reached the place. Eslinger’s head was turned toward the engine when I got to him; his head was about two or three feet from the end of the plank. Erom the point where 'he went in to make the coupling to where his body was found, he would have had to pass over the end of the plank in some way. I d.o not know how he got over the end of the planks; he could have been dragged over this step-off. I think the plank are two and a half inches thick, and it is down .grade there, and cinders and sand and dirt have washed in there until it is nearly level; it could not have been more than an inch step-off. It was a public crossing, and had been so planked two or three months. It is now in about the same condition as it was on the night of the accident; the step-off is just as it was when the crossing was completed. I think Eslinger had been coupling for 'two or three months. "We coupled over this track every night. There is no chance for 'him to get his foot caught in the place where the flange of the wheel runs; it is too wide; the planks are bevelled off for the flange to run in. I made a careful examination of the brake-beam that night, to see if I could find anything wrong with it. I found nothing wrong. I looked to see if I could see auy signs of where his foot had been caught, hut found nothing. I never measured it, hut suppose the brake-beam was about, seven or eight inches high. I never saw anything wrong with any part of it; beam was in good condition and seemed to he hung right. I saw no nuts or holts projecting from it. The brake-rod goes through the beam right under the draw-head. To have been caught by the bolt on the brake-beam, he would have to he right square under the bumper. I do not think the nut was off. I could find no place where he could have been caught. The holt that comes through the brake-shoe does not affect the height of the beam. The only way to change the height of the beam is to take it down and change the length of the hanger rods. The holts on the end of the beam have nothing to do with the height of the beam; they are put there to hold the brake-shoes on. I looked to see what could have caused the accident, and could not find a thing. I saw no evidence of his having been dragged over 'the planks. When this coupling was made I was coming hack very slowly, barely moving; had my hand on air-brake throttle, and when Torrence signaled me down I Stopped at once. I think the train moved about five feet after he gave me the signal. I was looking right at him when he gave it. He out me down as soon as I felt the jar of the ears coming together. I cannot understand how Eslinger’s head came to he turned toward the engine. The witness last referred to further testified that Eslinger had told him (he had a weak ankle; and that on two occasions bis ankle bad given way under bim as he attempted to step on the foot-hoard of the engine witness was driving, and came near being injured. Witness advised him to quit the job he held and get another, and he said he thought he would. There was testimony by plaintiff and two other witnesses who had long known Eslinger, that they never s'aw or heard of any weakness in this respect; that they were frequently with him, and he was rather an active man, etc. Maddox <& Starr, for plaintiff. Payne <& Tye and R. J. <& J. MeOamy, for defendant.