Swift Spinning Mills v. Crouch

Broyles, P. J.

I. The petition was good as against the general grounds of the demurrer.

2. Two of the special grounds of the demurrer to the petition should have been sustained: (a) The 11th paragraph of the petition was subject to the special ground of the demurrer interposed. (6) Sub-paragraph 7 of paragraph 12 was subject to the special demurrer.

3. The court erred in overruling the special grounds of the demurrer referred to, but properly overruled the general grounds, and the other special grounds thereof.

Judgment reversed.

Bloodworth and Stephens, JJ., concur. Paragraph 5 was amended by adding that the plank was about 2 feet long and about 6 inches across and was soft pine without knots.' The petition was further amended as follows: (a) The saw was a circular rip-saw 12 inches in .diameter and extended through ajp. iron table (from the under side), and the table was about é feet long and about 3 feet wide, and the opening in the table was about a half inch wide where the saw protruded about two inches. The teeth on the saw when properly filed were a half inch long. The saw revolved toward plaintiff as it cut the pieces, of wood he was holding, and, on account of the small size of. the teeth and their being gummed with sawdust and gum or rosin from wood that had been cut with it, he could not tell that some of the teeth were long and some short, without cleaning or inspecting them; which it was not his duty to do. The bearings were two cast metal boxes filled with bobbitt metal, in which were set the two ends of the shaft on which the saw was set, and- the babbitt metal was worn and allowed considerable play or loss in the-running of the saw, which was not apparent while the saw was revolving or running idle, but it would wabble and run untrue when it was sawing; which was not apparent without an inspection of the bearings and removing the boxes, which it was not plaintiff’s duty to do. (b) The rip-saw was located at the south end of the machinery department of the winder room on the first floor, and' plaintiff started the saw by a pulley that threw the belt on the shafting, he not being able to tell, from the small distance that the saw protruded through the iron table, that it was not set true and running true in the bearings, and not being able to tell the varying length of the teeth, from the small protrusion of the saw and also from the gummed condition of the sawdust collected on the saw and table. After the saw started to running he took the said piece of board and held it against the saw with both of his hands until it became necessary to held the board back of the saw, on account of its being ripped near where he was holding it.. Then he caught the said board back of the saw with Ms left hand until he could move his right hand from the end of the board near himself “(pushing) to end beyond the saw pulling, when the saw caught the plank and kicked it out and jerked his hand against the saw, inflicting said injuries.” The demurrer to the petition as amended was on the grounds-: (1) It appears that there is no right in the plaintiff to maintain the action. (2) No cause of action is set forth. (3) It appears that the plaintiff by ordinary care could have.avoided the injury. (4) It appears that the injury was caused by the plaintiff’s own negligence. (5) It appears that the alleged defects in the saw and its bearings were not the. proximate cause of the injury. (6) It appears that the plaintiff had equal means and opportunity with the defendant of ascertaining the alleged looseness in the bearings. (7) It appears that the plaintiff had a better opportunity than the defendant of knowing that the saw would wabble and run untrue when sawing. (8) The petition does not show how long before the injury the plaintiff had been operating the saw and to what extent he had been using it. (9) There is no allegation showing that by ordinary care the plaintiff could not have known of the danger of pulling the b.oard at the rear of the saw with his left hand. (10) The allegations in paragraph 6 are (a) mere conclusions of the pleader, and (5) are contradicted by other allegations of fact. (11) It is not shown how, why, or in what manner the alleged dangerous condition of the rip-saw caused the plank to kick back and threw the plaintiff’s hand on the rip-saw. (12-15) Allegations in paragraphs 7 and 12 are demurred to as conclusions of the pleader and as not showing how the alleged negligence caused the plank to kick back and injure the plaintiff. Subparagraph 1 of paragraph 12 was demurred to on the ground that it appears from the allegations of the petition as amended that the alleged defects of the machinery were not the proximate cause of the injury. (16) Subparagraph 7 of paragraph 12 was demurred to as a conclusion and because no facts are alleged showing that it was the duty of the master mechanic to true up the rip-saw and repair it. (17) Paragraph 11 is demurred to on the ground that the allegation that the plaintiff was capable of earning $5 per day is irrelevant and immaterial, and vague and indefinite, in that there is no averment of what the plaintiff had been earning before or at the time of the accident. (18) The allegation in paragraph b of the amendment, that “it became necessary to hold said board back of said saw,” is demurred to as a mere conclusion. The court overruled each ground of the demurrer. Slade & Swift, A. W. Cozart, for plaintiff in error. McCutchen & Bowden, Love & Fort, contra.