This case is before the Court on a certified question from the United States Court of Appeals for the Eleventh Circuit.1 Doyle v. Volkswagenwerk Aktiengelellschaft, 81 F3d 139 (11th Cir. 1996). The question certified is:
When an automobile manufacturer sells an automobile to a Georgia citizen and the automobile is in compliance with the National Automobile Safety Act,2 does Georgia law preclude a personal injury product liability claim?
The answer to this question is no. Georgia common law permits a Georgia citizen to sue an automobile manufacturer despite the manufacturer’s compliance with the standards established by the National Automobile Safety Act. As we stated in Banks v. ICI Americas,3 “compliance with industry-wide practices, state of the art, or federal regulations does not eliminate conclusively [a manufacturer’s] liability for its design of allegedly defective products.”
The Eleventh Circuit’s question arises from a defective products case brought by Victoria and Duffey Doyle in the United States District Court for the Northern District of Georgia. While Victoria Doyle was driving her new 1989 Volkswagen Jetta on August 18, 1989, she was struck in the rear by another vehicle, and as a result Ms. Doyle sustained severe injuries to her right breast. Ms. Doyle obtained expert opinion that her injuries were caused by the Jetta’s shoulder *575belt and absence of a lap belt, that is, that without a lap belt to absorb a portion of the impact force, a majority of that force was focused on Ms. Doyle’s right breast. The Jetta was manufactured by Volkswagenwerk Aktiengesellschaft (Volkswagen AG) and imported and marketed by Volkswagen of America, Inc. (Volkswagen USA). Both the Jetta’s driver’s seat and front passenger seat were designed and equipped with automatic shoulder belts, but no lap belts.4 Instead of a lap belt, the Jetta utilized: (1) a torso shoulder belt with automatic locking retractor; (2) an energy absorbing knee bolster; (3) a specially designed anti-submarining seat; and (4) outboard seat belt anchorage. This fully passive restraint system was authorized under Federal Motor Vehicle Safety Standard 208.5
The Doyles’ complaint set out three theories of liability: negligence, strict liability, and breach of implied warranty of fitness. Both the Doyles and the Volkswagen defendants filed motions for partial summary judgment. Defendants alleged that because the Jetta seat belt system complied with federal motor vehicle safety standards, they were entitled to judgment as a matter of law because either: (1) they had no duty under Georgia law to exceed federal standards; or (2) plaintiffs’ common law claims were preempted by the federal standards.
The district court concluded that the Jetta’s seat belt system complied with the applicable federal standards despite the absence of a lap belt. The court also concluded that Honda Motor Co. v. Kimbrel6 precluded recovery for negligently creating a defective condition when the vehicle manufacturer is in compliance with federal regulations. Thus, the defendants could not be liable under Georgia law for the absence of a lap belt.7 Accordingly, the district court denied relief *576to plaintiffs and granted the defendants’ motion for partial summary judgment. The parties then filed a joint statement agreeing that the district court’s ruling effectively precluded all of the plaintiffs’ claims, and the district court entered judgment for the defendants.
The Eleventh Circuit agreed that the Jetta seat belt system complied with applicable federal standards governing automobile restraints.8 It was uncertain, however, whether the district court correctly interpreted Georgia law when it relied on Kimbrel to preclude the Doyles from pursuing their common-law actions.9 The Eleventh Circuit certified its question after finding in Banks v. ICI Americas “persuasive data” that this Court might render a decision contrary to Kimbrel.10
The Court of Appeals decision in Kimbrel was based on the premise that the Georgia standard of duty with respect to occupant protection and restraints did not exceed Standard 208, and for that reason the absence of passive restraints or airbags could not be considered a defective condition so as to establish a breach of duty on the part of an automobile manufacturer. The Volkswagen defendants argue that Kimbrel is not in conflict with this Court’s decision in Banks, because Kimbrel represents only an exception to the Banks rule that compliance with federal or industry regulations is not conclusive proof of lack of liability. However, the argument pales in light of the paramount purpose of the Safety Act, that is, to reduce traffic injuries and save lives.11 Such an “exception” would impede the achievement of that goal because it would permit what has been stated to be only minimum standards,12 as a matter of law, to represent our state’s standard of care. That outcome would “have the per*577verse effect of granting complete immunity from design defect liability to an entire industry. . . .”13
The Kimbrel doctrine predated our decision in Banks and is inconsistent with a risk-utility analysis.14 Under the risk-utility test, compliance with federal standards or regulations is a factor for the jury to consider in deciding the question of reasonableness, that is, whether the product design selected was a reasonable one from among the feasible choices of which the manufacturer was aware or should have been aware.15 It does not render a manufacturer’s choice of design immune from liability.16 That is not to say that evidence of such compliance is not significant, for it is. But, instead of acting as an impenetrable shield from liability, compliance, more appropriately, is to be a piece of the evidentiary puzzle.17
The focus of the Safety Act is to reduce deaths and injuries from automotive accidents by promoting and enhancing safer automobile design. To that end, we determine that our state common law permits its citizens to pursue a personal injury product liability claim against an automobile manufacturer even if the automobile is in compliance with the Safety Act.18 This decision will not make the manufacturer an insurer of its product, for there is no duty to design an accident-proof vehicle. All we do today is affirm that proof of compliance with federal standards or regulations will not bar manufacturer liability for design defect as a matter of law.
Question answered.
All the Justices concur, except Fletcher, P. J, who dissents.1983 Ga. Const., Art. VI, Sec. VI, Par. IV; OCGA § 15-2-9.
The National Traffic and Motor Vehicle Safety Act of 1966. Pub. L. No. 89-563, 80 Stat. 718 (1966) (codified at 15 USC §§ 1381-1431). The current version of the Act is found at 49 USC §§ 30101-30169 (1995) due to a recodification of transportation provisions in the United States Code. In order to be consistent with the federal decisions in this case, the prior codification will be cited.
264 Ga. 732, 736, n. 6 (450 SE2d 671) (1994). (Emphasis supplied.)
The Doyles allege that upon purchasing the Jetta, Ms. Doyle was told that the design was perfectly safe without a lap belt.
49 CFR § 571.208 (1987). Standard 208 was first adopted in 1967, and it initially required the installation of manual lap belts in all new automobiles. The standard was amended in 1972 to require a gradual phase-in of passive restraints, i.e., air bags, automatic seat belts, padded interiors, etc. The standard was again amended in 1974 in response to public outcry against ignition/seat belt interlock systems. The 1974 amendment also authorized the National Highway Transportation Safety Administration (NHTSA) to adopt a standard that permitted manufacturers to install either passive restraint systems or manual belt systems. This authorization led to an amended Standard 208 which granted manufacturers the option to install one of three restraint systems: (1) passive restraints for front and lateral crashes; (2) passive restraints for front crashes plus lap belts for side crashes and rollovers; or (3) manual seat belts alone. Taylor v. General Motors Corp., 875 F2d 816 (11th Cir. 1989), cert. denied, 494 U. S. 1065 (110 SC 1781, 108 LE2d 783) (1990). For additional history on Standard 208, see Motor Vehicle Mfrs. Assn. v. State Farm. Mut. Auto. Ins. Co., 463 U. S. 29, 34-38 (103 SC 2856, 77 LE2d 443) (1983).
189 Ga. App. 414 (376 SE2d 379) (1988), cert. denied, 189 Ga. App. 912.
Having found plaintiffs’ claims precluded under Georgia law, the district court found it unnecessary to reach the preemption issue.
Doyle at 141.
The district court relied on the statement in Kimbrel: “Because the Georgia standard of duty does not exceed the federal, Georgia would mandate only that federal standards be met .’’Doyle at 141, citing Kimbrel at 419 (2).
Doyle at 143.
The Safety Act was passed to ensure the “establishment of safety standards for motor vehicles in interstate commerce [and] to reduce traffic accidents and the deaths, injuries, and property damage which occur in such accidents ...” S. Rep. No. 1301, 89th Cong., 2d Sess. 3, reprinted in 1966 U.S.C.C.A.N. 2709, 2710. See also State Farm Mut. Auto. Ins. Co. v. Dole, 802 F2d 474, 477 (D.C. Cir. 1986), cert denied, 480 U. S. 951 (107 SC 1616, 94 LE2d 800) (1987). (Congress passed the Safety Act in 1966 in response to escalating injuries and deaths from traffic accidents.)
The Safety Act defines a safety standard as a “minimum standard for motor vehicle performance, or motor vehicle equipment performance, which is practicable, which meets the need for motor vehicle safety and which provides objective criteria.” (Emphasis supplied.) 15 USC § 1391 (2). The legislative history is also telling. The Senate Conference Report stated that “the Federal minimum safety standards need not be interpreted as restricting State common law standards of care, [and] [c]ompliance with such standards would thus not necessarily shield any person from product liability at common law.” (Emphasis supplied.) S. Rep. No. 1301, 89th Cong., 2d Sess. 12, reprinted in U.S.C.C.A.N. 2709, 2720.
Medtronic, Inc. v. Lohr, 518 U. S. _ (116 SC 2240, 2251, 135 LE2d 700) (1996).
Kimbrel is overruled to the extent that it conflicts with the Banks standard for product liability design defect cases.
See Banks at 734, 736.
See Restatement (Third) of Torts: Products Liability, § 7 (b) (Tentative Draft No. 2 1995) (a product’s compliance with an applicable product safety statute or regulation is properly considered in determining whether a product is defective, but does not necessarily preclude as a matter of law a finding of product defect); Restatement (Second) of Torts, § 288C (1965) (compliance with a legislative enactment or an administrative regulation does not prevent a finding of negligence where a reasonable man would take additional precautions); W. Keeton et al., Prosser and Keeton on the Law of Torts, 233 (5th ed. 1984) (compliance with a statutory standard is evidence of due care, it is not conclusive on the issue).
See Shipp v. General Motors Corp., 750 F2d 418, 421 (5th Cir. 1985).
See Polston v. Boomershine Pontiac-GMC Truck, 262 Ga. 616, 618 (423 SE2d 659) (1992). (There is a question of public policy when considering a position which diminishes the incentive of automobile manufacturers to design their products in a responsible fashion. Products actions have deterrent value.)